Yokogawa - Service & Support

KNOWLEDGEBASE

Filter your results by Category or Keyword

What are the Differences Between Unbalanced, Balanced, Isolated and Differential Input?

Unbalanced, non-isolated inputs are single-ended amplifiers. These inputs are suitable for measurements where common mode voltages are extremely small or zero and measurements are referenced to GND. Unbalanced, isolat...

item: 1077 | http://tmi.yokogawa.com/in/service-support/faqs/1077/

Is There a Screenshot of the ScopeCorder Instrument Cart?

Please see the attached screenshot images of the ScopeCorder instrument cart. ...

item: 123 | http://tmi.yokogawa.com/in/service-support/faqs/123/

Can the 702911 and 702912 be Used with the DL750 DL750P?

The 702911 and 702912 Logic Probes cannot be used with the DL750/DL750P. The logic probes were orginally designed to be used with the OR Series. The SL1400 can use the 700986, 700987, 702911, 702912. The DL750 can onl...

item: 755 | http://tmi.yokogawa.com/in/service-support/faqs/755/

What is Warranty Period for 701934-D and 700938-3-D Active Probe Power Supply?

The warranty period for the 701934-D and 700938-3-D Active Probe Power Supply is 1 year. ...

item: 754 | http://tmi.yokogawa.com/in/service-support/faqs/754/

In Serial Bus Analysis Which Standard is it Necessary to Use a Differential Probe?

There are three kinds of standards for which a differential probe is necessary: FlexRay CAN UART (Some but not all UART) It is not necessary to use a differential probe for the LIN, I2C and SPI standards. ...

item: 407 | http://tmi.yokogawa.com/in/service-support/faqs/407/

What is the Dimension Specification of the 701906 Long Test Clip?

The dimension specifications of the 701906 Long Test Clip is provided in the attached file. Please refer to the PDF for more information....

item: 561 | http://tmi.yokogawa.com/in/service-support/faqs/561/

Is There an Alternative Solution to Using a 10:1 Probe for Higher Voltage Input?

One possible solution is to use a third party 10:1 attenuator such as the one shown in the attached document. You may use the attenuator to allow the direct input of higher voltage levels with the 701262 module, since it...

item: 239 | http://tmi.yokogawa.com/in/service-support/faqs/239/

Can I Replace the T/DIV Knob on the DL1540?

Yes, please visit our Contact Website and contact your local Yokogawa Representative to request a replacement for part no. A9080ZG....

item: 1210 | http://tmi.yokogawa.com/in/service-support/faqs/1210/

What Happens if I Extend a Passive Probe Using BNC/Coax?

This method will not work as the signal waveform would be very distorted. The coax acts as a heavy shunt-capacitance at the 'output' jack of the passive probe circuit. As a result, this excessive shunt-capacitance attenu...

item: 954 | http://tmi.yokogawa.com/in/service-support/faqs/954/