What does VARIABLE feature do on Yokogawa DL750 ScopeCorder?

What does VARIABLE feature do on DL750 ScopeCorder?

In terms of using VARIABLE on your input channel;
it is a display-value feature - not a resolution feature.

the A/D on the front-end still uses the V/Div which you had previously set.

Here is a different approach:

Divide your signal’s Vpp by 20 divisions; and be sure to adjust your V/Div no-higher-than that value.

Now, your waveform will be off-screen a bit, by as much as 10 divisions-worth of waveform that you cannot see;

No problem, simply adjust the V Zoom to a value less than X1. This keeps the A/D in the best resolution mode; and, this will improve your SNR (ratio).

You may also use the VARIABLE feature after you setup according to 20 input divisions (veritcal).

Related Products & Solutions

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

Yokogawa high-speed data acquisition systems
Industry-leading isolation, bit resolution, sampling rate, and memory depth
Independent channel hardware and easy to use software

Oscilloscopes

Digital oscilloscopes
High-speed sampling
Range of bandwidths for electronic device design and development
Advantages of oscilloscope and multi-channel data recorder

ScopeCorders

Flexible, high-performance Yokogawa ScopeCorder
Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
Captures high-speed transients and low-speed trends

Top