Is the Delay Measurement Value a Fixed-Point or Floating Point Number?
The Delay Measurement value is a Fixed-Point Number.
The Delay Measurement feature on the DL850 comes in two modes, Time and Degree. The output of the Delay Measurement feature is a time-based value and not an amplitude value. The method used to calculate the delay is based on the sampling rate and the number of data points between the trigger point to the measurement target. Therefore the output value is a Fixed-Point because the measurement depends on the sampling rate resolution.
The Delay Measurement feature on the DL850 comes in two modes, Time and Degree. The output of the Delay Measurement feature is a time-based value and not an amplitude value. The method used to calculate the delay is based on the sampling rate and the number of data points between the trigger point to the measurement target. Therefore the output value is a Fixed-Point because the measurement depends on the sampling rate resolution.
Related Products & Solutions
Data Acquisition (DAQ)
Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.
High Speed Data Acquisition
- Yokogawa high-speed data acquisition systems
- Industry-leading isolation, bit resolution, sampling rate, and memory depth
- Independent channel hardware and easy to use software
Oscilloscopes
- Digital oscilloscopes
- High-speed sampling
- Range of bandwidths for electronic device design and development
- Advantages of oscilloscope and multi-channel data recorder
ScopeCorders
- Flexible, high-performance Yokogawa ScopeCorder
- Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
- Captures high-speed transients and low-speed trends
Top