How do I Programatically Determine the Start and End Point of the Zoom Box for the DL850 ScopeCorder?
To determine the start and end point of the zoom box for DL850 ScopeCorder, issue the following commands:
- :WAVEFORM:START
- :WAVEFORM:END
- :ZOOM:POSITION?
- :ZOOM:MAG?
- :ZOOM:POSITION1?
- :ZOOM:MAG1?
- :WAVEFORM:LENGTH?
You can then calculate the zoom start and end points by using the following equations:
- Zoom Start = [Wave Length * (5 + Zoom Position) / 10 div - (Wave Length/Zoom Mag)] /2
- Zoom End = Zoom Start + Wave Length / Zoom Mag
Related Products & Solutions
Data Acquisition (DAQ)
Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.
High Speed Data Acquisition
- PC-based, local or remote operation
- Stream and capture fast transients & complex waveforms
- Modular, independent channel hardware
Oscilloscopes
- Digital oscilloscopes
- High-speed sampling
- Range of bandwidths for electronic device design and development
- Advantages of oscilloscope and multi-channel data recorder
ScopeCorders
- An integrated measurement system for every electromechanical application
- Modular platform combines oscilloscope and DAQ functionality
- Capture high-speed transients and low-speed trends
Top
