How do I Programatically Determine the Start and End Point of the Zoom Box for the DL850 ScopeCorder?

To determine the start and end point of the zoom box for DL850 ScopeCorder, issue the following commands:
  • :WAVEFORM:START
  • :WAVEFORM:END
  • :ZOOM:POSITION?
  • :ZOOM:MAG?
  • :ZOOM:POSITION1?
  • :ZOOM:MAG1?
  • :WAVEFORM:LENGTH?

You can then calculate the zoom start and end points by using the following equations:

  • Zoom Start = [Wave Length * (5 + Zoom Position) / 10 div - (Wave Length/Zoom Mag)] /2
  • Zoom End = Zoom Start + Wave Length / Zoom Mag

Related Products & Solutions

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

  • Yokogawa high-speed data acquisition systems
  • Industry-leading isolation, bit resolution, sampling rate, and memory depth
  • Independent channel hardware and easy to use software

Oscilloscopes

  • Digital oscilloscopes
  • High-speed sampling
  • Range of bandwidths for electronic device design and development
  • Advantages of oscilloscope and multi-channel data recorder

ScopeCorders

  • Flexible, high-performance Yokogawa Test&Measurement ScopeCorder
  • Modular platform combines mixed signal oscilloscope and portable data acquisition recorder 
  • Captures high-speed transients and low-speed trends 

Precision Making

Top