DL850 ScopeCorder G3 Power Measurement on a Sinusoid-Current Burst

The DL850 ScopeCorder G3 Power Measurement option can be used to calculate the power of a Sinusoid-Current Burst. Please download and view image for a screenshot demonstration of the DL850 G3 Power Function.

The firmware version of the DL850 when the screenshot was taken was version 1.35. The G3 Power Function was used to measure six cycles of a 100Hz, 10Apeak current burst from a static 10Vpeak voltage supply. The trigger was set to trigger on the rising edge of CH12 at the 0.0V zero-crossing. The DL850 G3 Power Function was used to calculate power (Watts) on a cycle-by-cycle basis with a one-cycle delay.

Related Products & Solutions

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

  • Yokogawa high-speed data acquisition systems
  • Industry-leading isolation, bit resolution, sampling rate, and memory depth
  • Independent channel hardware and easy to use software


  • Digital oscilloscopes
  • High-speed sampling
  • Range of bandwidths for electronic device design and development
  • Advantages of oscilloscope and multi-channel data recorder


  • Flexible, high-performance Yokogawa ScopeCorder
  • Modular platform combines mixed signal oscilloscope and portable data acquisition recorder 
  • Captures high-speed transients and low-speed trends 


Precision Making