Is There any Dead Time Between Files When Recording Multiple Files From the SL1000 High-Speed Data Acquisition Unit?
Depending on the mode, the dead time may range from 0 to 10ms approximately. The dead time for the different modes are listed below.
-
Free Run Mode: 0ms
-
Normal Mode without HDD recording: 10ms
-
Normal Mode with HDD recording: 10ms + HDD recording time
-
Single(N) Mode: 10ms
Another important concern is whether there is any data loss between multiple files, in which case the answer is no. The SL1000 High-Speed Data Acquisition Unit allocates enough internal memory to buffer incoming data for save operations and therefore, data is not lost.
Related Products & Solutions
SL1000 High Channel Count ScopeCorder
A headless ScopeCorder system capable of connecting multiple chassis into one PC-based system.
Data Acquisition (DAQ)
Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.
High Speed Data Acquisition
- Yokogawa high-speed data acquisition systems
- Industry-leading isolation, bit resolution, sampling rate, and memory depth
- Independent channel hardware and easy to use software
Oscilloscopes
- Digital oscilloscopes
- High-speed sampling
- Range of bandwidths for electronic device design and development
- Advantages of oscilloscope and multi-channel data recorder
ScopeCorders
- Flexible, high-performance Yokogawa ScopeCorder
- Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
- Captures high-speed transients and low-speed trends
Top
