Noise/Glitch Occurring on the Unterminated Input Sub-Channel for the 720221 Module

Noise or glitches occurring on the unterminated input sub-channel for the 720221 module is normal.  
You must install a short-circuit jumper on the input terminal which is not used. The wave becomes GND level and glitches will not appear.

Another method is to set the Burn-Out function to ON through the CH » Temperature Setup menus. If Burn-Out is set to ON and the input sub-channel is unterminated, the DL850 will interpret the status of the TC as disconnected. So the wave becomes HI level over ranged positions.

Please see the attached file for an example screenshot.

Related Products & Solutions

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

  • Yokogawa high-speed data acquisition systems
  • Industry-leading isolation, bit resolution, sampling rate, and memory depth
  • Independent channel hardware and easy to use software


  • Digital oscilloscopes
  • High-speed sampling
  • Range of bandwidths for electronic device design and development
  • Advantages of oscilloscope and multi-channel data recorder


  • Flexible, high-performance Yokogawa ScopeCorder
  • Modular platform combines mixed signal oscilloscope and portable data acquisition recorder 
  • Captures high-speed transients and low-speed trends 


Precision Making