I Can't Establish Communications with the Measuring Station When Connecting to the Ethernet via Serial Communication

After entering the communications settings with serial communications, use the main power switch on the back of the measuring instrument to perform a power cycle. Also, in the MS DOS prompt window, try executing the command "ping XXX.XXX.XXX.XXX" (where XXX.XXX.XXX.XXX is the IP address for the WE7000). If the message, "Reply from..." is displayed that means the communications settings were successfully entered, but if the "Time out..." message is displayed please check the TCP/IP settings on the PC and the cable connections.

Related Products & Solutions

WE7000 PC-Based Measurement Instruments

One system, multiple instruments: WE7000 satisfies demands for fast, reliable and precise data acquisition which uses a standard laptop or PC as its user interface. Input modules plug into an expandable measuring station. Via the optical interface, it is possible to galvanically isolate the laptop/PC.

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

Yokogawa high-speed data acquisition systems
Industry-leading isolation, bit resolution, sampling rate, and memory depth
Independent channel hardware and easy to use software