DL350 Assistant Software

This software can be utilized for ScopeCorder DL350 data and setup file management by a PC.
Data files or setup configuration files stored in the DL350 SD card can be backed up with the press of a button.
Remote setting, start-stop control and setup file editing can also be easily done on the connected PC.

This software supports setup operations and on-site tasks of the DL350.
You can use this software to perform the functions listed below.

Function Overview
Load Setup File You can directly apply a DL350 setup file stored in the PC to the DL350.
DL350 Start/Stop You can start or stop measurement performed on the DL350.
Backup You can back up the data stored in the SD card or USB memory installed with the DL350 to the PC.
Transfer File You can transfer (copy) files bidirectionally between the DL350 and PC.
Edit Setup File You can edit the DL350 setup file stored in the PC.

System Requirement

Recommended Environment
Install this software on a PC having an environment where one of the OSs listed below runs.

OS
Windows 7(32bit/64bit), Windows 8(32bit/64bit), Windows 8.1(32bit/64bit), and Windows 10(32bit/64bit)

Communication Interface
USB2.0
Ethernet 100BASE-TX/10BASE-T

DL350 Firmware and Software Version Compatibility Table

DL350 firmware version Version of this software
1.10 and later 1.10 and later
1.01 to 1.02 1.01 to 1.02
1.20 and later 1.20 and later
Version Added Function
1.20 and later
  • CAN/CAN FD Monitor Module (720242) was added.
1.10 and later
  • A timeout setting was added to the duty cycle measurement of the FV setting on the frequency module.
  • The fast channel multiplexing function of the SENT monitor module is now supported.
  • A battery level check function was added.
  • GPS settings were organized into a table.
1.02 and later
  • Setting category items (Measure, Analysis) were added to Edit Setup File.
1.01 and later
  • New release

Procurando mais informações sobre nossas pessoas, tecnologia e soluções?


Contate-nos

Precision Making

Topo