I am Unable to Run the WE7000 Control Software After Installing and Connecting the Control Software to the PC

If you are using serial communication or ethernet to connect the WE7000 Control Software to the PC, it is necessary to create a shortcut with a start option added to the end of the shortcut target. For WE control software V3.1.2 and later, a shortcut is created automatically after installation. For instructions on setting the start option, please see section 3.2 "Installing the WE7000 Control Software" in the WE7000 User's Manual IM707001-01E.

Related Products & Solutions

WE7000 PC-Based Measurement Instruments

One system, multiple instruments: WE7000 satisfies demands for fast, reliable and precise data acquisition which uses a standard laptop or PC as its user interface. Input modules plug into an expandable measuring station. Via the optical interface, it is possible to galvanically isolate the laptop/PC.

Data Acquisition (DAQ)

Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.

High Speed Data Acquisition

Yokogawa high-speed data acquisition systems
Industry-leading isolation, bit resolution, sampling rate, and memory depth
Independent channel hardware and easy to use software

ScopeCorders

Flexible, high-performance Yokogawa ScopeCorder
Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
Captures high-speed transients and low-speed trends