Can the GS610 or GS820 be Used as a DMM to Only Measure Voltage?

No, the GS610 and the GS820 cannot be used solely as a DMM to measure only voltage. This is because the Sense terminal cannot be separated from the Output terminal on the instrument. The GS Series uses the Output terminal to source and measure the DUT, it is NOT using the Sense terminal for measurement. The Sense terminal is used only in the case of the 4-wire mode.  
  • In 2-wire mode, the Sense terminal is internally connected to the Output terminal and cannot be used.
  • In 4-wire mode, the Sense terminal is internally connected to the Output terminal by a 40kΩ resistor.
For the single channel GS610, the Output and Sense terminal must be connected at the same point. For the multi-channel GS820, you can use CH1 and CH2 to measure separate parts of the DUT.

Please refer to the attached PDF for a diagram of the 2-wire and 4-wire connection method.

Related Products & Solutions

GS200 DC Voltage / Current Source

The GS200 is a low voltage/current DC source with high accuracy, high stability, and high resolution.



GS610 Source Measure Unit

The GS610 is made up of a programmable current and voltage source, a voltmeter, and an ammeter. Each function can be combined into numerous operation modes.

GS820 Multi Channel Source Measure Unit

  • Yokogawa source measure unit GS820
  • Precision SMU quick response for automated testing
  • High-speed communication improves productivity
  • Customizable to enable any test

Signal Generators, Sources and Supplies

For general purpose standalone applications or as core components in a high speed test and measurement system, Yokogawa sources and signal generators are highly accurate and functional.

Source Measure Units

A Source Measurement Unit (SMU) is a flexible test instrument which is capable of both sourcing and measuring voltage and/or current at the same time.

Precision Making