How do I Programatically Determine the Start and End Point of the Zoom Box for the DL850 ScopeCorder?
To determine the start and end point of the zoom box for DL850 ScopeCorder, issue the following commands:
- :WAVEFORM:START
- :WAVEFORM:END
- :ZOOM:POSITION?
- :ZOOM:MAG?
- :ZOOM:POSITION1?
- :ZOOM:MAG1?
- :WAVEFORM:LENGTH?
You can then calculate the zoom start and end points by using the following equations:
- Zoom Start = [Wave Length * (5 + Zoom Position) / 10 div - (Wave Length/Zoom Mag)] /2
- Zoom End = Zoom Start + Wave Length / Zoom Mag
Related Products & Solutions
Data Acquisition (DAQ)
Simplify complex testing with DAQ systems that flex to your needs. Capture and analyze any physical or electrical signal with ease, transforming signals into actionable insights that speed innovation and improve reliability.
High Speed Data Acquisition
- PC-based, streaming, local or remote operation
- 20+ modules, isolated and versatile inputs
- Up to 200 MS/s or 640 ch
Isolated Oscilloscopes | ScopeCorders
- An integrated measurement system for every electromechanical application
- Modular platform combines oscilloscope and DAQ functionality
- Capture high-speed transients and low-speed trends
Oscilloscopes
Accelerate design and troubleshooting with oscilloscopes that combine high-speed sampling, long record lengths, and mixed-signal analysis. From quick debug to advanced R&D, Yokogawa oscilloscopes help you see deeper, work faster, and design smarter.
Top