Troubleshooting DL7400 Digital Oscilloscope USB Communication Error Using LabVIEW
Resources:
When communicating or controlling the DL7400 Digital Oscilloscope via USB in LabVIEW, you must use the USB driver files provided by NI-VISA (Version 3.0 or later). The Yokogawa USB driver files labeled YKUSB or YKMUSB can be used when LabVIEW is not used to communicate with the instrument.
In case both driver files are installed, you will need to update to driver file in Windows Device Manager. Please refer to the attached document file for the procedures for updating the USB driver file.
Related Products & Solutions
DL7440/DL7480 Digital Oscilloscopes
8-channel 500 MHz oscilloscope with 16 logic inputs, for applications where four channels aren't enough. Support for eight analog channels, 16 bits with 250MHz logic bandwidth, 16MP of recording memory, power analysis, serial bus analysis, and a broad selection of voltage and current probes.
DL9000 DSO Series
500MHz, 1.0GHz, and 1.5GHz DSOs for debug and high performance applications. 10th
generation oscilloscope from Yokogawa with industry leading 2.5 million wfms/sec and lowest dead time. Winner of Test & Measurement World's "Best in Test" award.
Mixed Signal Oscilloscopes
- Yokogawa mixed signal oscilloscopes
- Simultaneous, time correlated observations
- Analysis of analog with digital (logic) signals
- Troubleshooting electrical anomalies, measuring parametric values, monitoring signals
Oscilloscopes
- Digital oscilloscopes
- High-speed sampling
- Range of bandwidths for electronic device design and development
- Advantages of oscilloscope and multi-channel data recorder