Is There a Method to Perform Deskew on a DL850 ScopeCorder When Using a Current Probe?
Resources:
Yokogawa DL850 ScopeCorder Deskew
It is not necessary to perform deskew on a DL850 ScopeCorder when using a current probe. The Yokogawa DL850 ScopeCorder does have enough resolution to perform deskew and will not be able to find the time offset.
Typically the deskew value ranges from ± 100ns in 0.01 ns steps. This means that for skew levels less than 100ns, the resolution of the skew must be 0.01ns. However, the resolution for the DL850 ScopeCorder with the max 100Ms/s module only has 10ns resolution. For the 10Ms/s module the resolution is 100ns. In both modules, there is insufficient resolution to detect the skew.
Please download the file for an explanation of deskew, taken from the DLM2000 instruction manual IM710105-01E. See the DL850 ScopeCorder Manual and Getting Started Guide for full configuration, features, preparations, measurements, operations, specifications, etc.
Related Products & Solutions
Data Acquisition (DAQ)
Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.
High Speed Data Acquisition
- Yokogawa high-speed data acquisition systems
- Industry-leading isolation, bit resolution, sampling rate, and memory depth
- Independent channel hardware and easy to use software
Oscilloscopes
- Digital oscilloscopes
- High-speed sampling
- Range of bandwidths for electronic device design and development
- Advantages of oscilloscope and multi-channel data recorder
ScopeCorders
- Flexible, high-performance Yokogawa Test&Measurement ScopeCorder
- Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
- Captures high-speed transients and low-speed trends
Top