UART, I2C/SPI/SM, CAN/LIN/Flexray: Tips & Tricks for Serial bus Protocol Analysis & Physical layer Troubleshooting using MSOs Webinar

Serial data buses have become increasingly common, core components of most electronic designs. As a design or test engineer, you presently need to use a protocol analyzer, logic analyzer, digital oscilloscope, or a combination of all three in order to debug serial bus signals. However, none of these instruments by themselves give you a complete picture of the physical and protocol layers—until now.Mixed signal oscilloscopes with serial bus analysis capability are ideal for monitoring bus traffic, detecting anomalies, and pinpointing their causes (i.e. too much noise, skew between signals, low signal levels, slow rise times, etc.) Armed with detailed waveform and protocol information captured and analyzed by the oscilloscope, you can easily witness signal behavior on the bus, monitor time correlated interactions, and quickly correct problems.This online seminar will: