When Performing a "ZONE" Search Using DL750 ScopeCorder History, if "No Matching Record" is Found in History, the DL750 Displays a Warning Message. Is There a Programmatic Method to Check/Read This Warning Message?
Unfortunately there is no way to read these warning messages on the DL750 ScopeCorder. In addition, there is no other command available to determine if there was "No Matching Record" found in History for a particular ZONE condition.
Typically, if you had 20 records in HISTORY, and you performed a ZONE condition search, then to find all the records (in History) that matched the ZONE condition programmatically, you will have to perform a series of command sequences to determine those record numbers.
Example
Example
Assumptions:
- "-20" records in History
- After executing ":HISTORY:EXECUTE", record numbers -3, -9, and -15 matched the ZONE condition.
The program script to determine the record numbers that matched the ZONE condition will be as follows:
:HISTORY:RECORD?
Reply is “-3”
:HISTORY:DISPLAY -4,-20
:HISTORY:RECORD?
Reply is “-9”
:HISTORY:DISPLAY -10,-20
:HISTORY:RECORD?
Reply is “-15”
:HISTORY:DISPLAY -16,-20
:HISTORY:RECORD?
Reply is “-15”
Reply is “-3”
:HISTORY:DISPLAY -4,-20
:HISTORY:RECORD?
Reply is “-9”
:HISTORY:DISPLAY -10,-20
:HISTORY:RECORD?
Reply is “-15”
:HISTORY:DISPLAY -16,-20
:HISTORY:RECORD?
Reply is “-15”
When the reply to ":HISTORY:RECORD?" is the same as previous query, this means that there are no more records availble in History that matched the ZONE condition.
相关产品和解决方案
示波记录仪
- Flexible, high-performance Yokogawa ScopeCorder
- Modular platform combines mixed signal oscilloscope and portable data acquisition recorder
- Captures high-speed transients and low-speed trends
返回顶部
微信扫一扫
获得更多专业服务
获得更多专业服务