Why are the Measured Values for VAR and ΣVAR Unstable?

Check the Synch Source and Frequency Filter settings

When a single-phase signal being measured fluctuates around power factor of 1.

Slight fluctuations in the measured values of voltage, current, and power can cause a large instabilities in the calculation of Var (around power factor 1) and ΣVar. In this case, to stabilize the measured values of voltage, current, and power, check the sync source setting and zero cross filter setting.
When a three-phase signal being measured fluctuates around a phase angle of 30 degrees.

In the case of zero cross filter (frequency filter), three-phase three-wire, or 3V3A wiring, in the vicinity of phase angle 30°, input to the power meter is the same condition as the above single-phase measurement. For details, see The power, power factor, and phase angle of each input element do not match when measuring the balanced three-phase load. Therefore, slight fluctuations in the measured values of voltage, current, and power or instable leading/lagging detection can cause large instabilities in the calculation of Var and ΣVar.

PZ4000设计用于高频功率测量以及瞬时功率测量。此仪器的实时采集系统可执行按周期的功率测量。一到四个输入单元提供0.2%的基本精度，具备2MHz的带宽和5MS/秒的数字化速率。

中等量程的WT500小巧且便于使用。使用其彩色TFT显示器可以观测数值和波形测量。提供1到3个输入单元，基本功率精度为0.1%，带宽为100kHz。

高端WT1800是WT1600的升级产品，可应用于从节能到高负载应用在内的各种应用领域。WT1800拥有6单元输入能力，可提供最大的灵活性和5MHz带宽下0.1%的基本功率精度。

WT3000高精度功率分析仪提供最高精度的测量。此产品已成为行业标准，用于变频器、电机驱动器、照明系统和电子镇流器、UPS系统、飞机电力系统、变压器测试和其它电力转换设备的研发。WT3000的基本功率精度达0.02%，带宽为1MHz。

功率计或称瓦特计，可以测量产生、转换或消耗电能的设备各项特征，包括设备的各项参数，如：功率（瓦特）、功率因数、谐波和效率等等。

YOKOGAWA数字功率分析仪，性能优越、测量可靠，支持各种应用，非常值得拥有。尤其是YOKOGAWA WT300E功率计，在全球功率计市场上口碑与地位日益跃升。