How do I Programatically Determine the Start and End Point of the Zoom Box for the DL850 ScopeCorder?
To determine the start and end point of the zoom box for DL850 ScopeCorder, issue the following commands:
- :WAVEFORM:START
- :WAVEFORM:END
- :ZOOM:POSITION?
- :ZOOM:MAG?
- :ZOOM:POSITION1?
- :ZOOM:MAG1?
- :WAVEFORM:LENGTH?
You can then calculate the zoom start and end points by using the following equations:
- Zoom Start = [Wave Length * (5 + Zoom Position) / 10 div - (Wave Length/Zoom Mag)] /2
- Zoom End = Zoom Start + Wave Length / Zoom Mag
Related Products & Solutions
Data Acquisition (DAQ)
Yokogawa data acquisition systems give you the most flexibility and power to measure, display, store, and even actuate any number of physical or electrical phenomena.
High Speed Data Acquisition
- Yokogawa high-speed data acquisition systems
- Industry-leading isolation, bit resolution, sampling rate, and memory depth
- Independent channel hardware and easy to use software
Top