Harmonic measurements

How to Measure Harmonics with the WT3000E Harmonic Measurement Meter

Harmonic measurements in compliance with IEC61000-3-2 harmonics standards
The WT3000E can be used to perform harmonic measurements in compliance with EN61000-3-2 Ed. 2.2. Note that this capability requires the /G6 option. Yokogawa also release a very useful software application.


Measurement of up to 50 orders of harmonics at 1 KHz
The WT3000E is useful for evaluating harmonics in equipment such as aircraft, in which the fundamental frequency changes to harmonics. Note that this capability requires the /G6 option.


Harmonic measurements on four input elements
The WT3000E can also be used to observe changes in the harmonic distortion factor in each phase. Note that this capability requires the /G6 option.


Measurement of phase angles between phases
The WT3000E harmonic test can determine the phase angle formed between the voltage fundamental wave of input element 2 or 3, and the voltage fundamental wave of input element 1. It can also determine the phase angle formed between the current fundamental wave of input element 1, 2 or 3, and the voltage fundamental wave of input element 1. Note that this capability requires /G5 or /G6 option.

Related Industries

Related Products & Solutions

PX8000 - Precision Power Scope

  • Transient/Start-up Waveform Capture & Power Analysis
  • Harmonics, Cycle by cycle and FFT analysis

Power Analyzers and Power Meters

Yokogawa, the world's largest manufacturer of energy and power analyzers and meters, provides a broad choice of digital power analyzers to satisfy all requirements.

ScopeCorders

  • Flexible, high-performance Yokogawa ScopeCorder
  • Modular platform combines mixed signal oscilloscope and portable data acquisition recorder 
  • Captures high-speed transients and low-speed trends 

 

Precision Making

Top